Malibu V6-3.9L (2007)
1. Install the NEW power steering gear oil seal (1) to the power steering gear using the seal installation end of the J 44586 (2).
2. Ensure the power steering gear oil seals (1) are fully seated in the power steering gear.
3. Position the power steering gear inlet pipe into the vehicle.
Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
Notice: Refer to Fastener Notice.
4. Install the inlet pipe (2) to the power steering gear and install the retaining bolt (1).
Tighten the power steering gear inlet/outlet pipe retaining bolt to 27 N.m (20 lb ft).