Malibu V6-3.9L (2007)
Notice: Refer to Fastener Notice.
2. Use a M6x1 TORX(R) head bit to attach the motor/module assembly (2) to the steering column with the 2 new TORX(R) bolts (1).
Tighten the steering column bolts to 9 N.m (80 lb in).
3. Connect the sensor wire harness (3) to the motor/module assembly (2).
4. Install the sensor wire harness strap clip (4) into the motor/module assembly (2).
5. Install the knee bolster.
6. Perform the control module setup. Refer to Control Module References for programming and setup information. See: Testing and
Inspection/Programming and Relearning