Malibu V6-3.9L (2007)
Stabilizer Shaft Insulator Replacement (Extended Sedan)
Stabilizer Shaft Insulator Replacement (Extended Sedan)
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the muffler assembly.
3. Disconnect the fuel pump module electrical connector from the underbody wiring harness.
4. Disconnect the evaporative emissions (EVAP) vent valve solenoid harness electrical connector from the underbody wiring harness.
5. Suitably support the gas tank.
6. Remove the front fuel tank strap bolts.
7. Remove the fuel tank heat shield.
8. Lower the fuel tank as necessary for access.
9. Remove the stabilizer shaft bracket bolts.
10. Remove the stabilizer shaft insulators from the stabilizer shaft.
Installation Procedure
1. Install the stabilizer shaft insulators.
2. Install the stabilizer shaft brackets.
Notice: Refer to Fastener Notice.
3. Install the stabilizer shaft bracket bolts.
