Malibu V6-3.9L (2007)
Band Apply Servo: Service and Repair
4T45-E - Automatic Transaxle
Low/Reverse Servo Assembly Replacement
Low/Reverse Servo Assembly Replacement
Removal Procedure
Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a
hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
1. Position the vehicle on a hoist and raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the transaxle oil pan.
3. Remove the oil feed pipe-to-low/reverse servo assembly bolt.
Important: Remove servo cover bolts evenly to prevent damage to servo cover.
4. Remove the low and reverse band servo cover assembly bolts.
5. Pull the oil feed pipe away from the servo cover and remove the servo assembly.
Disassembly Procedure
1. Remove the piston pin assembly from the servo cover.
2. Remove the snap ring from the servo pin.
3. Remove the piston and the servo cushion springs from the servo pin.
4. Remove the servo piston seals from the cover.
5. Discard the servo piston seals.