Malibu Classic L4-2.2L (2008)
2. Install the license lamp socket to the lamp housing. Turn the socket clockwise to seat the socket.
3. Tilt the license lamp. Insert the lamp through the opening in the rear bumper fascia.
4. Holding the rear side of the license lamp, hand-start the license lamp screw on one side of the lamp.
Notice: Refer to Fastener Notice.
5. From the front side of the license lamp, position the lamp to the fascia. Hand-start the screw on the other side of the lamp.
Tighten the license lam screws to 2 N.m (18 lb in).
