Malibu Classic L4-2.2L (2008)
9. Fill the transaxle to the proper level. Refer to Fluid Capacity Specifications.
10. Inspect the transaxle fluid level.
11. Inspect for fluid leaks.
Front Wheel Drive Shaft Oil Seal Replacement - Right
Front Wheel Drive Shaft Oil Seal Replacement - Right Side
Tools Required
*
J 6125-B Slide Hammer
*
J 23129 Universal Seal Remover
*
J 29130 Axle Shaft Seal Installer
*
J 37292-B Axle Seal Protector
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the right front tire and wheel.
3. Remove the right stabilizer shaft link from the right lower control arm.
4. Remove the right tie rod end from the right steering knuckle.
5. Remove the right lower ball joint from the right steering knuckle.
6. Remove the right drive axle from the transaxle.
7. Secure the right drive axle to the right steering knuckle and the strut.
8. Use the J 6125-B (3) and the J 23129 (4) to remove the oil seal (1) from the extension housing (2).
Installation Procedure
1. Lubricate the seal lip with transaxle fluid.
2. Install J 37292-B in the seal (4).
3. Use J 29130 to install the new seal (4).
4. Remove the J 37292-B.
Important: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface.
5. Install the drive axle to the transaxle.
6. Install the right lower ball joint to the right steering knuckle.
7. Install the right tie rod end to the right steering knuckle.
8. Install the right stabilizer shaft link to the right steering knuckle.
