Metro L3-061 1.0L VIN 6 TBI (1998)
Radio/Stereo: Service and Repair
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative (-) battery cable.
2. Disconnect the following connectors from the radio by accessing through the instrument panel compartment:
^
The radio electrical connector
^
The antenna connector
3. Remove the ashtray from the track by pushing down on the retainer and pulling out.
4. Remove the following components from the instrument panel:
4.1. 4 screws (1)
4.2. The center trim bezel (3)
5. Remove the cross-recess screw (1) from under the back of the radio. Access the screw through the ashtray cutout in the instrument panel.
6. Remove 4 screws from the front of the radio.
7. Remove the radio with the mounting bracket from the vehicle.
8. Remove 5 screws and 3 radio mounting brackets from the radio, if necessary.
INSTALLATION PROCEDURE