Metro L3-061 1.0L VIN 6 TBI (1998)
ABS Light Relay: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the Negative (-) battery cable.
2. Disconnect the lamp driver relay electrical connector.
3. Remove the lamp driver relay retaining bolt and remove the lamp driver relay (3).
INSTALLATION PROCEDURE
1. Install the lamp driver relay (3) and the retaining bolt to the vehicle.
^
Tighten the relay retaining bolt to 8 Nm (71 inch lbs.).
NOTICE: Refer to Service Precautions.
2. Connect the lamp driver relay electrical connector.
3. Connect the Negative (-) battery cable.
4. Perform the "Diagnostic System Check".