Metro L3-061 1.0L VIN 6 TBI (1998)
INSTALLATION PROCEDURE
1. Install the Hydraulic modulator assembly into the vehicle.
2. Install Hydraulic modulator assembly to bracket mounting nuts (5).
^
Tighten the Hydraulic modulator bracket mounting nuts to 5.4 Nm (48 inch lbs.).
NOTICE: Refer to Service Precautions.
3. Connect the brake pipes (1) to the hydraulic modulator (2).
^
Tighten the tube nuts to 15 Nm (11 ft. lbs.).
4. Connect the Brake Motor Pack electrical connector.
5. Connect the two brake solenoid valve electrical connectors.
6. Connect the Negative (-) battery cable.
IMPORTANT: Bleed the system.
7. Perform the "Diagnostic System Check".
