Metro L3-061 1.0L VIN 6 TBI (1998)
1. 1. Lubricate the seal on the new brake solenoid valve (2) with clean brake fluid.
1. 2. Verify the brake solenoid valve lip seal (3) is properly positioned before installing the brake solenoid valve (2) in the ABS brake modulator
(4).
2. Position the brake solenoid valve (2) so the brake solenoid valve electrical connector will face the same direction as the brake solenoid valve that
was removed.
3. By hand, press down firmly on the brake solenoid valve (2) until the brake solenoid valve flange seats on the ABS brake modulator (4).
4. Install the Torx head bolts (1).
^
Tighten the Torx head bolts to 5 Nm (44 inch lbs.) .
NOTICE: Refer to Service Precautions.
IMPORTANT: Verify proper installation of the brake solenoid valve connectors on the correct brake solenoid valve.
5. Reconnect the brake solenoid valve electrical connector.
6. Bleed the brake modulator/motor pack assembly.
7. Perform the "Diagnostic System Check".
Modulator Gear Cover Replacement
REMOVAL PROCEDURE
1. Remove the Brake Modulator Assembly.
2. Remove six Torx head screws (5) that retains the gear cover to the hydraulic modulator/motor pack assembly (1).
3. Remove the gear cover (4).
