Metro L3-061 1.0L VIN 6 TBI (1998)
Brake Pad: Testing and Inspection
Inspect the linings when the wheels are removed (tire rotation, etc) and as suggested in the maintenance schedule located in Maintenance and
Lubrication.
Check both ends of the outer pad by looking through the lining inspection hole in the caliper. These are the points where the highest rate of wear
normally occurs. At the same time, check the thickness of the inner pad to ensure that it has not worn prematurely. Replace the pad if the minimum
thickness of 1 mm (0.04 in) has been exceeded.
