Metro L3-061 1.0L VIN 6 TBI (1998)
Parking Brake Cable: Service and Repair
REMOVAL PROCEDURE
NOTICE: Use care when performing service operations on or around parking brake cables. Damage to the plastic coating will reduce corrosion
protection and if the damaged area passes through the seal, increased parking brake effort could result. Contacting the coating with sharp-edged tools,
or with sharp surfaces of the vehicle underbody, should be avoided.
1. Remove the parking brake lever trim bezel.
2. Loosen the adjuster nut (3) on the parking brake lever assembly.
3. Remove the parking brake cable (2) from the parking brake lever assembly equalizer plate (4).
4. Raise and support the vehicle.
5. Remove the rear tire and wheel assemblies.
6. Remove the two guide brackets from the cable (2).
7. Remove the cable grommet (1) from the floor pan. Pull the cable out.
8. Remove the drums.
9. Remove the parking brake cable from the shoe lever.
10. Remove the parking brake cable from the backing plate.