Metro L3-061 1.0L VIN 6 TBI (1998)
Lifter / Lash Adjuster: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the Valve Rocker Arm Cover.
3. Remove the timing belt.
4. Remove the camshaft.
IMPORTANT:
^
Never disassemble the Hydraulic Valve Lash (HVL) adjuster.
^
Do not apply force to the body of the adjuster or the oil in the high pressure chamber.
^
Submerge the removed adjusters in clean engine oil until reinstallation. If the adjusters are left in the air, place with the adjuster bodies facing
down. Do not place on the side or with the adjuster bodies facing up.
5. Remove the six Hydraulic Valve Lash (HVL) Adjusters (1) from the cylinder head.
INSTALLATION PROCEDURE
1. Pour engine oil through the camshaft journal holes (2).
2. Inspect that the engine oil comes out from the oil holes in the HVL adjuster bores.