Metro L3-061 1.0L VIN 6 TBI (1998)
9. Install the camshaft housing No.1 (1) to the camshaft and the cylinder head with the arrow on the camshaft housing (2) facing the timing belt side.
IMPORTANT: Apply a light amount of engine oil to the housing bolts before securing the camshaft housings to the camshaft journals.
10. Install the two remaining camshaft housings (2, 3) to the journals of the camshaft.
11. Secure the camshaft housings with the housing bolts.
^
Tighten the bolts a little at a time and evenly among the bolts. Repeat the tightening process three or four times until they are tightened to 11
Nm (97 ft. lbs.).
12. Apply engine oil to the camshaft oil seal lip.
13. Press-fit the camshaft oil seal until the oil seal surface becomes flush with the housing surface.
14. Install the camshaft.
15. Install the timing belt.
16. Install the Valve Rocker Arm Cover.
