Metro L3-061 1.0L VIN 6 TBI (1998)
16. Remove the following components from the cylinder block.
^
The eight cylinder head bolts.
^
The cylinder head with the gasket.
17. Remove the rod bearing caps.
NOTICE: Install a piece of hose over the threads of the rod bolts. This is to prevent damage to the bearing journal, the cylinder walls or rod bolt
threads when installing the connecting rod. Remove hose after connecting rod is in place.
18. Install a piece of hose over the threads of the rod bolts (1).
IMPORTANT: Decarbon the top of the cylinder bore before attempting to remove the piston from the cylinder.
19. Remove the piston and the connecting rod assembly out through the top of the cylinder bore.
INSTALLATION PROCEDURE
^
Tools Required
-
J 8037 Piston Ring Compressor.
