Metro L3-061 1.0L VIN 6 TBI (1998)
NOTE: Inspect pump drive belt alignment on power steering pump pulley and crankshaft drive pulley before adjusting belt tension.
2. Adjust pump drive belt tension.
NOTE: Measure power steering pump drive belt deflection using thumb pressure (approximately 10 kg (22 lbs.). A properly adjusted drive belt
should deflect 7 to 9 mm (0.28 to 0.35 inch).
3. Tighten belt tension pulley nut.
NOTE: Tighten belt tension pulley nut to 45 Nm (33 ft. lbs.).
4. Right front lower splash shield; secure with six push cups.
5. Right front tire and wheel assembly.
6. Lower vehicle.
NOTE: A "new belt" is a belt with less than 5 minutes of running time on an engine. A "used belt" is a belt with more than 5 minutes of running
time on an engine.