Metro L3-061 1.0L VIN 6 TBI (1998)
Important: The outer and inner bearing cartridges differ in size. The outer cartridge is smaller in diameter than the inner cartridge. Both bearing
cartridges are installed using the J 34842 Rear Wheel Bearing Installer. The two sides of the tool correspond to each bearing cartridge size.
1. install the outer bearing to the outboard side of the brake drum/hub assembly (1) using the J 34842 and the J 7079-2.
Important: The assembly will not fit on the knuckle spindle if the spacer lip faces toward the inner bearing.
2. Install the bearing spacer to the brake drum/hub assembly. Ensure that the inner lip faces toward the outer bearing.
3. Install the inner bearing to the inboard' side of the brake drum/hub assembly (1) using the J 34842 and the J
4. On non ABS equipped vehicles, install the brake drum/hub assembly to the knuckle spindle. On ABS equipped vehicles, install the wheel hub to
the knuckle spindle.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
5. Install the washer and the spindle nut to the knuckle spindle.
Tighten
^
On wheel hub equipped vehicles, tighten the spindle nut to 170 Nm (120 ft. lbs.).
^
On non wheel hub equipped vehicles, tighten the spindle nut to 100 Nm (74 ft. lbs.).
6. Stake the spindle nut.
7. Install the spindle nut dust cap. On wheel hub equipped vehicles, install the brake drum to the wheel hub. Secure the brake drum with the two
recessed screws.
8. install the rear tire and wheel assembly. Refer to WHEEL REMOVAL.
9. Lower the vehicle.
