Metro L3-061 1.0L VIN 6 TBI (1998)
13. Remove the four bolts and the TBI unit.
Installation Procedure
1. Install the new gasket onto the early fuel evaporation (EFE) heater.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the TBI unit to the EFE heater and secure with the four bolts.
Tighten
Tighten the TBI unit bolts to 23 N.m (17 lb ft).
3. Install the accelerator cable to the cable bracket.
4. Rotate the throttle lever to the wide open position.
