Metro L3-061 1.0L VIN 6 TBI (1998)
Impact Sensor: Service and Repair
Front End Discriminating Sensor
Important Preliminary Precautions
CAUTION: Be careful when you handle a sensor. Do not strike or jolt a sensor. Before applying power to a sensor:
^
Remove any dirt, grease, etc. from the mounting surface.
^
Position the sensor horizontally on the mounting surface.
^
Point the arrow on the sensor toward the front of the vehicle.
^
Tighten all of the sensor fasteners and sensor bracket fasteners to the specified torque value.
Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.
Removal Procedure
1. Disable the SIR system. Refer to Disabling the SIR System.
2. Disconnect the Connector Position Assurance (CPA) (4) and the electrical connector (1).
3. Disconnect the pigtail from the pigtail clips.
4. Remove the inflatable restraint front end discriminating sensor fasteners.
5. Remove the inflatable restraint front end discriminating sensor (3) from the vehicle.
Installation Procedure
