Metro L3-061 1.0L VIN 6 TBI (1998)
Shift Interlock Solenoid: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative (-) battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Remove 2 screws and the selector knob (1) from the selector lever (6).
3. Remove 4 screws and the console from the vehicle.
4. Remove 4 screws, the upper cover and the slide cover from the selector lever.
5. Remove the lower cover from the selector lever.
6. Remove the shift lock solenoid (9) electrical connector under the carpet.
7. Remove the 2 retaining screws and the shift lock solenoid (2) from the selector lever housing (1).
INSTALLATION PROCEDURE
1. Move the selector lever to the P position.
2. Apply lithium grease GM P/N 1051344 to the upper and the lower edges of the solenoid lock plate at position 3 as shown in the figure.
3. Install the shift lock solenoid to the selector lever housing. Secure with 2 retaining screws (2). Do NOT tighten fully.
4. Install the shift lock solenoid electrical connector under the carpet.
5. Adjust the shift lock solenoid position so that the solenoid will operate in the manner described below.
