Metro L3-061 1.0L VIN 6 TBI (1998)
7. Support the steering knuckle. Use the J 41392.
8. Remove the bearing assembly from the knuckle. Use the J 7079-2 and the J 41391.
9. Inspect the inner and outer bearing oil seals for wear or deterioration. Replace the seals at the slightest signs of failure.
10. Inspect both bearings for wear, corrosion, and contamination by dirt or water. If any of these conditions exist, replace the bearing assembly.
INSTALLATION PROCEDURE
^
Tools Required:
-
J 39722 Wheel Bearing Race/Outer Seal Installer
-
J 7079-2 Driver Handle
-
J 41392 Front Hub Support/Inner Seal Installer
-
J 36050 Wheel Hub Race Installer
1. Support the steering knuckle (1). Use the J 41392
2. Install the bearing assembly into the knuckle (1). Use the J 39722 and the J 7079-2.
3. Install the outer bearing into the steering knuckle (1).
4. Install one snap ring to the outer side of the steering knuckle (1).
5. install the inner bearing and race into the steering knuckle (1).
