Metro L3-061 1.0L VIN 6 TBI (1998)
7. Install the speedometer driven gear case into the transaxle.
Use the speedometer driven gear case (1) retaining bolt in order to secure the speedometer driven gear case.
^
Tighten the speedometer driven gear case retaining bolt (2) to 7 Nm (62 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
8. Install the speedometer cable into the speedometer driven gear case.
Use the speedometer cable retaining clip in order to secure the speedometer cable.
9. Slide the speedometer driven gear case boot down the speedometer cable.
10. Slide the speedometer driven gear case boot over the speedometer driven gear case.
