Metro L3-061 1.0L VIN 6 TBI (1998)
1. Install the left transaxle mount into the vehicle.
2. Use a suitable hydraulic jack in order to raise the transaxle into position.
3. Install the left transaxle through bolt (1) into the left transaxle mount (4).
^
Tighten the left transaxle through-bolt to 60 Nm (44 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
4. Install the 2 transaxle mount retaining nuts (2).
^
Tighten the retaining nuts to 60 Nm (44 ft. lbs.).
5. Remove the hydraulic jack.
6. Install the left splash shield onto the vehicle.
7. Use the 5 retainer clips in order to secure the splash shield.
8. Lower the vehicle.
