Metro L4-079 1.3L VIN 2 MFI (2001)
Installation Procedure
1. Install the bracket onto the subframe.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install mounting bolts (4).
-
Tighten the bracket mounting bolts to 25 Nm (18 ft. lbs.).
3. Install the hydraulic modulator assembly. Refer to Brake Modulator Assembly Replacement.
Brake Modulator Gear Replacement
Removal Procedure
Caution: The modulator drive gears are under spring load and will turn during disassembly. After removing brake modulator drive gear cover,
exercise extreme care not to place fingers into the gear set, since fingers can be pinched by rotating gears.
Notice: Do not allow gear to turn while removing the retaining nut, since the modulator piston can hit the top of the modulator bore, damaging the
piston. Place a screwdriver through the holes in the gears (not between the gears) into the recessed hole in the modulator base. This will prevent the
gear from turning, aiding in gear removal.
Important: Do not repair damaged motor-pack assemblies or brake modulators. Besides modulator drive gears replacement, repair of the motor-pack
assembly and of the brake modulator assemblies is not authorized. Do not oil or lubricate the gears on the motor-pack assembly.
