Metro L4-079 1.3L VIN 2 MFI (2001)
1. Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the master cylinder and the new gasket to the vacuum booster. Secure with two mounting nuts (3) and washers.
-
Tighten the master cylinder mounting nuts to 13 Nm (115 inch lbs.).
3. Install the brake pipes to the master cylinder (and the proportioning valve on models with ABS). Secure with brake pipe nuts.
-
Tighten the master cylinder brake pipe flare nuts to 16 Nm (12 ft. lbs.).
4. Connect the fluid level switch electrical connector.
5. Connect the negative battery cable. Refer to Battery Cable Replacement.
6. Bleed the brake system. Refer to Hydraulic Brake System Bleeding.
