Metro L4-079 1.3L VIN 2 MFI (2001)
Manifold Absolute Pressure (MAP) Sensor: Service and Repair
REMOVAL PROCEDURE
1. Remove the bolt from the bracket that retains the Manifold Absolute Pressure (MAP) sensor.
2. Lift the MAP sensor from the intake plenum.
3. Disconnect the MAP sensor electrical connector.
4. Remove the MAP sensor from the MAP sensor bracket.
INSTALLATION PROCEDURE
1. Install the MAP sensor to the MAP sensor bracket.
2. Connect the MAP sensor electrical connector.
3. Install the MAP sensor to the vacuum port of the intake plenum.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the MAP sensor bracket bolt.
Tighten
Tighten the bolt to 10 N.m (89 lb in).
