Metro L4-079 1.3L VIN 2 MFI (2001)
Transmission Position Switch/Sensor: Service and Repair
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Remove the PNP switch electrical connector at the engine wiring harness.
3. Remove the PNP switch harness from the retaining clamps.
4. Remove 1 bolt and the PNP switch (4) from the transaxle.
Installation Procedure
1. Move the transaxle lever (1) to the N position.
