Metro L4-079 1.3L VIN 2 MFI (2001)
2. Adjust the PNP switch (1) by using a standard flat-bladed screwdriver. Turn the PNP switch clockwise or counterclockwise until you hear 2 clicks.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the PNP switch (4) to the transaxle. Install the bolt (1) in order to retain the switch.
Tighten the PNP switch mounting bolt to 23 Nm (17 ft. lbs.).
4. Connect the PNP switch electrical connector at the engine wiring harness.
5. Install the PNP switch harness into the retaining clamps.
6. Connect the negative battery cable
7. Upon completion of the PNP switch installation, perform the following steps in order to ensure proper operation:
^
Apply the parking brake, and block the vehicle wheels.
^
With the manual selector lever (5) in the P position, turn the ignition switch to the START position. Verify that the starter motor operates.
^
Stop the engine, and return the ignition switch to the ON position.
^
Move the shift selector lever (5) from the P position to the N position. Turn the ignition switch to the START position, and verify that the
starter motor operates.
