Monte Carlo V6-204 3.4L DOHC VIN X SFI (1996)
Oil Pump Drive Shaft: Service and Repair
Oil Pump Drive Assembly
Remove or Disconnect
1. Remove rear cylinder head as outlined under Cylinder Head / Service and Repair.
2. Remove oil pump drive mounting bolt and clamp.
3. Remove oil pump drive assembly.
4. O-ring.
Install or Connect
1. O-ring.
^
Lubricate with engine oil.
2. Oil pump drive.
^
Lubricate drive gear with grease.
3. Clamp and mounting bolt.
Tighten
^
Bolt to 36 N.m. (27 lb. ft.).
4. Right (rear) cylinder head. Refer to Cylinder Head / Service and Repair.
