Monte Carlo V6-204 3.4L DOHC VIN X SFI (1996)
Voltage Signal: Description and Operation
Cruise Control Status Signal
DESCRIPTION
The stepper motor cruise control module sends the cruise status input to the PCM to indicate when cruise control is engaged. The PCM monitors the
cruise status signal while commanding cruise to be disengaged via the cruise inhibit circuit. Any of the following conditions may cause the PCM to
inhibit cruise control operation:
^
Engine not running long enough for cruise control operation.
^
Transaxle range inputs indicate park, neutral, low, or reverse gear selected.
^
Engine speed is too high or too low.
^
Vehicle speed is too high or too low.
^
ABS system is active for longer than 2 seconds.
^
Vehicle acceleration or deceleration rate is too high.
