Monte Carlo V6-204 3.4L DOHC VIN X SFI (1996)
Transmission Position Switch/Sensor: Service and Repair
Transaxle Range Switch Service
Transaxle Range Switch Adjustment
REMOVAL PROCEDURE
1. Set park brake.
2. Set gear selector lever to Neutral (N).
3. PNP switch and transaxle range switch electrical connectors.
4. Nut securing linkage cable to transaxle manual shaft.
5. Linkage cable from manual shaft
6. Two bolts securing PNP switch to transaxle.
7. PNP switch.
INSTALLATION PROCEDURE
After the PNP switch has been installed, verify that the engine only starts in Park and Neutral. If the engine starts in any other position, readjust the PNP
switch.
1. Verify that the transaxle manual shaft is still in the Neutral position. If it has been moved, rotate the shaft clockwise from Park through Reverse
into Neutral. Be careful not to damage the shaft flats, corners, or threads.
2. PNP switch.
^
Align the flats in the PNP switch with the flats on the transaxle manual shaft.
^
Press the PNP switch onto the shaft and fully seat the PNP switch against the transaxle.