Monte Carlo V6-231 3.8L VIN A (1984)
FIGURE 3 - ALLEN WRENCH INTO CLUTCH FEED
3.
Using a 1/16" allen wrench mark short end as illustrated in Figure 2. Using the allen wrench as a gage, insert the small end into the forward clutch
feed orifice hole (Figure 3) and make sure the allen wrench goes into the orifice hole (without any drag) until the mark on the wrench is flush with
the ground diameter (Figure 3).
If it is necessary to replace any of the parts listed in this bulletin, refer to the chart below:
Housing Assembly
Forward Clutch
Turbine Shaft
Model
Forward Clutch
Piston Seals
Seals (Teflon R)
CZ, JY
8633948
8628924
ALL MODELS 8628090
BH, OI,
OR, OU
8638944
8628924