Monte Carlo V6-3.4L VIN E (2000)
Spoiler: Service and Repair
Rear Spoiler Replacement (without RPO BYP)
Rear Spoiler Replacement (Monte Carlo without RPO BYP)
Tools Required
J 25070 Heat Gun
Removal Procedure
Notice: Use of harsh chemicals when cleaning can damage exterior lamps. Suggested cleaners are a mild soap and water, or Varnish Makers and
Painters (VM&P) Naptha. VM&P Naptha is a specific type of naptha and should not be substituted by any other naptha.
1. Open the rear compartment.
2. Remove the nuts from the rear end spoiler studs.
3. Heat the rear end spoiler mounting points from the inside, using J 25070 152 mm (6 in) from surface.
Apply heat using a circular motion for about 30 seconds.
4. Remove the rear end spoiler from the rear compartment lid surface using a small wood or plastic flat-bladed tool. Do NOT damage the paint.
5. Remove the rear end spoiler from the rear compartment lid.
6. Clean the rear end spoiler adhesive from the rear compartment lid and/or the rear end spoiler using 3M(TM) Scotch Brite molding adhesive
remover disk, 3M(TM) P/N 07501, or equivalent.
7. Clean the body panel using VM&P Naphtha in order to remove any adhesive. Wipe the surface dry with a clean, lint-free cloth.
