Monte Carlo V6-3.4L VIN E (2000)
16. Install the clear plastic bleeder hose to the LEFT FRONT brake caliper bleeder valve.
17. Submerge the opposite end of the clear plastic bleeder hose in a clean container partially filled with clean brake fluid.
18. Open the bleeder valve.
19. Press and hold the brake pedal approximately 75 percent of a full stroke.
20. Close the bleeder valve.
21. Release the brake pedal.
22. Repeat Steps 18 through 21 until air bubbles are no longer detected in the brake fluid.
^
Tighten the brake caliper bleeder valve to 13 Nm (115 inch lbs.).
23. Remove the clear plastic bleeder hose from the bleeder valve.
24. Install the clear plastic bleeder hose to the LEFT REAR bleeder valve.
^
For vehicles with rear drum brakes, install the clear plastic bleeder hose to the wheel cylinder bleeder valve.
^
For vehicles with rear disc brakes, install the clear plastic bleeder hose to the brake caliper bleeder valve.
