Monte Carlo V6-3.4L VIN E (2000)
2. Install a new lubricated piston seal (4) into the caliper bore grooves. Ensure that the piston seal is not twisted.
3. Install the lubricated boot (1) onto the piston (2).
4. Lubricate the piston OD with clean brake fluid.
5. Install the piston and the boot into the bore of the caliper. Push the piston to the bottom of the bore.
6. Seat the caliper boot in the caliper housing (1) counterbore using J 36349.
7. Install the caliper. Refer to Brake Caliper Replacement (Front) or Brake Caliper Replacement (Rear).
Rear
Disassembly Procedure
1. Remove the caliper. Refer to Brake Caliper Replacement (Rear).
