Monte Carlo V6-3.4L VIN E (2000)
3.
Remove the caliper bracket bolts (2).
4.
Remove the caliper bracket (1).
Important:
To ensure that the proper clamp load will be present when installed, it is imperative that the threads on the caliper bracket bolts, as well as the
mounting holes in the knuckle, be cleaned of all debris and inspected before proceeding with installation.
5.
Clean and visually inspect threads of the caliper bracket bolts (2) and mounting holes in the knuckle.
6.
Apply LOCTITE(R) THREAD LOCKER 272 (GM P/N 12345493) or equivalent to the threads of the brake caliper bracket bolts (2).
7.
Install the caliper bracket (1) with the bracket bolts (2).
Tighten
Tighten the caliper bracket bolts to 115 N.m (85 lb ft).
8.
Install the rear brake pads.
9.
Install the caliper.
Disclaimer
