Monte Carlo V6-3.4L VIN E (2000)
1. Lubricate the following components with silicone grease:
^
The bolt boots (2)
^
The bushings
2. Install the following components into the caliper bracket (1):
^
The bolt boots (2)
^
The bushings
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the caliper bracket with the bracket bolts.
^
Tighten the caliper bracket bolts to 185 Nm (137 ft. lbs.).
4. Install the caliper. Refer to Brake Caliper Replacement (Front).
Brake Caliper Bracket Replacement - Rear
Removal Procedure
Important: Do not disconnect the brake hose from the caliper. Support or hang the caliper. Do not let the caliper hang from the brake hose.
1. Remove the caliper. Refer to Brake Caliper Replacement (Rear).
Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after
they become loose or are removed may cause loss of vehicle control and personal injury.
Important: The NEW brake caliper bolts come with an encapsulated thread compound already on the bolt.
2. Remove the caliper bracket bolts (2).
3. Remove the caliper bracket (1).