Monte Carlo V6-3.4L VIN E (2000)
1. Clean the BPMV surface with alcohol using a clean rag.
2. Install the EBCM (2) to the BPMV (3).
3. Install the four screws (1) that attaches the EBCM (2) to BPMV (3).
Notice: Refer to Fastener Notice in Service Precautions.
^
Tighten the four screws to 5 Nm (44 inch lbs.).
4. Connect the EBCM harness connector.
5. Push down lock tab (1) and then move sliding connector cover (2) back in the home position to lock.
6. Insert red locking tab back in place.
7. Turn the ignition switch to the RUN position, do not start engine.
8. Perform the A Diagnostic System Check - ABS.
