Monte Carlo V6-3.4L VIN E (2000)
Thermostat: Service and Repair
Thermostat Replacement
Removal Procedure
-
Tools Required
-
J 38185 Hose Clamp Pliers
1. Carefully remove the throttle body air inlet duct.
2. Partially drain the cooling system. Refer to Draining and Filling Cooling System.
3. Use the J 38185 in order to reposition the hose clamp at the thermostat housing.
4. Disconnect the radiator hose from the thermostat housing.
5. Remove the exhaust crossover pipe. Refer to Exhaust Crossover Replacement.
6. Remove the thermostat housing bolts.
7. Remove the thermostat housing and the gasket.
8. Remove the thermostat.
9. Clean the mating surfaces.