Monte Carlo V6-3.4L VIN E (2000)
1. Install a new right valve rocker arm cover gasket to the valve rocker arm cover.
Important: Apply sealant GM P/N 12345739 or equivalent at the cylinder head to lower intake manifold joint.
2. Apply sealant at the cylinder head to lower intake manifold joint at the rear of the lower intake manifold (1).
Important: Apply sealant GM P/N 12345739 or equivalent at the cylinder head to lower intake manifold joint.
3. Apply sealant at the cylinder head to lower intake manifold joint at the front of the lower intake manifold (1).
4. Install the right valve rocker arm cover. Refer to Valve Rocker Arm Cover Installation (Right Side).
5. Install the vacuum hose to the grommet in the right valve rocker arm cover.
6. Install the ignition coil bracket with coils. Refer to Ignition Control Module Replacement in Computers and Controls.
7. Install the AIR check valve/pipe (if equipped) and the evaporative emission canister purge solenoid valve. Refer to AIR Check Valve/Pipe
Replacement - Bank 1 in Computers and Controls.