Monte Carlo V6-3.4L VIN E (2000)
3. Install the right exhaust manifold gasket. Install the right exhaust manifold. Refer to Exhaust Manifold Installation (Right Side).
4. Install the right exhaust manifold heat shields. Refer to Exhaust Manifold Installation (Right Side).
5. Install the EGR valve to the intake manifold. Refer to EGR Valve Replacement in Computers and Controls.
6. Install the three-way catalytic converter pipe to the right exhaust manifold. Refer to Catalytic Converter Replacement in Powertrain Management.
7. Lower the vehicle.
8. Connect the oxygen sensor wiring harness connector.
9. Install the exhaust crossover pipe nuts to the right exhaust manifold. Refer to Exhaust Crossover Replacement.
10. Install the exhaust crossover pipe heat shield. Refer to Exhaust Crossover Replacement.
11. Install the AIR check valve/pipe if equipped. Refer to AIR Check Valve/Pipe Replacement - Bank 2 in Computers and Controls.
12. Install the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Computers and Controls.
13. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.
