Monte Carlo V6-3.4L VIN E (2000)
Start to remove the module case seal (blower motor side of case) seal (2) from the lower module case at the position shown (1).
9. Remove the temperature valve, if equipped with C60.
IMPORTANT: The LH and RH temperature valves separate in the center.
10. Remove the temperature valves (1,2), if equipped with CJ3.
Carefully pull the temperature valves apart in the center to remove the temperature valves from the HVAC module case.
INSTALLATION PROCEDURE
IMPORTANT: The LH and RH temperature valves pivot in the center.
1. Install the temperature valves (1,2), if equipped with CJ3.
Carefully align the temperature valves into the HVAC module case.
