Monte Carlo V6-3.4L VIN E (2000)
4. Install the J 33020 into the inner circle of slots in the rotor.
5. Turn the J 33020 clockwise in the slots in order to engage the tangs of the puller with the segments between the slots in the rotor.
6. Hold the J 33020 in place. Tighten the puller screw against the puller guide in order to remove the puller rotor and bearing assembly.
7. Support the rotor hub in order to prevent damage to the pulley rotor during bearing removal.
7.1.
Remove the forcing screw from the J 33020.
7.2.
With the tangs of the J 33020 still engaged in the rotor slots, invert the assembly onto a solid, flat surface or blocks.
NOTE: It is not necessary to remove the staking in front of the bearing to remove the bearing, however, it will be necessary to file away the old stake
metal for proper clearance for the new bearing to be installed into the rotor bore or the bearing may be damaged.
8. Use a J 9398 with the J 8092 in order to drive the bearing out of the rotor hub.
Clutch Rotor and/or Bearing Install
TOOLS REQUIRED
^
J 6083 Snap Ring Pliers
^
J 8092 Driver Handle
^
J 8433-1 Puller Bar
^
J 8433-3 Forcing Screw
^
J 9481-A Bearing Installer
^
J 21352-A Support Block
^
J 33017 Pulley And Bearing Assembly Installer
^
J 33019 Bearing Staking Tool
^
J 33023-A Puller Pilot
^
J 34992 Compressor Holding Fixture
NOTE: Do not support the rotor by resting the pulley rim on a flat surface during the bearing installation or the rotor face will be bent.
