Monte Carlo V6-3.4L VIN E (2000)
Compressor Clutch Bearing: Service and Repair
Clutch Rotor and/or Bearing Install (V5 - Conventional Mount)
TOOLS REQUIRED
^
J 6083 Snap Ring Pliers
^
J 8092 Driver Handle
^
J 8433-1 Puller Bar
^
J 8433-3 Forcing Screw
^
J 9481-A Bearing Installer
^
J 21352-A Support Block
^
J 33017 Pulley And Bearing Assembly Installer
^
J 33019 Bearing Staking Tool
^
J 33023-A Puller Pilot
^
J 34992 Compressor Holding Fixture
NOTE: Do not support the rotor by resting the pulley rim on a flat surface during the bearing installation or the rotor face will be bent.
1. Place the pulley rotor on the J 21352-A in order to fully support the rotor hub during the bearing installation.
2. Align the new bearing with the hub bore.
3. Using the J 9481-A and the J 8092, drive the bearing into the hub.
The J 9481-A applies force to the outer race of the bearing.
4. Place the J 33019 and the staking pin in the hub bore.
5. Shift the rotor and bearing assembly on the J 21352-A in order to fully support of the hub under the location of the staking pin.
6. Use a heavy-duty rubber band (1) in order to hold the stake pin in the guide of the J 33019.
IMPORTANT: Do not allow a metal stake to contact the outer face of the bearing in order to prevent distortion of the outer race.
7. Using care in order to prevent injury, strike the staking pin of the J 33019. Properly position the stake pin in the guide after each impact on the pin.
8. Continue to strike the pin of the J 33019 until a stake, similar to the original stake, is formed down to, but not touching, the bearing.
