Monte Carlo V6-3.4L VIN E (2000)
3. Install the rubber access cover to the headlamp for the headlamp bulb you are replacing.
4. Connect the electrical connector to the headlamp.
5. Install the headlamp retainers through holes in the upper fascia support and the tender reinforcement.
6. Install the headlamp retainers, by sliding downward until fully seated.
7. Check the headlamp aim, If a new headlamp was installed, or if service or repairs in the front end area were made. Refer to Headlamp Aiming
(Impala) or Headlamp Aiming (Monte Carlo).
8. Install the radiator air baffel as required.
9. Close the hood.
