Monte Carlo V6-3.4L VIN E (2000)
3. Install the power steering return line to the power steering gear. Refer to Power Steering Return Hose Replacement.
4. Install the power steering return line to the clamp on the power steering gear.
5. Install the power steering return hose from the power steering pump to the power steering cooler pipe.
6. Use the utility stand in order to raise the frame.
7. Install NEW frame bolts to the rear of the frame. Refer to Frame Removal in Frame and Underbody.
8. Install the intermediate steering shaft to the power steering gear stub shaft. Refer to Intermediate Steering Shaft Replacement in Steering Wheel
and Column-Tilt.
9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
10. Remove the drain pan from under the vehicle.
11. Lower the vehicle.
12. Install the engine mount struts to the engine. Refer to Engine Mount Strut Replacement (Left) and Engine Mount Strut Replacement (Right) in
Engine.
13. Fill the power steering fluid reservoir. Refer to Refilling the Power Steering System.
14. Bleed the power steering system. Refer to Bleeding the Power Steering System.
15. Inspect the power steering system for leaks. Refer to Steering and Suspension Leaks.
