Monte Carlo V6-3.4L VIN E (2000)
8. Use three wheel nuts in order to attach the J 28733-B to the wheel bearing/hub.
9. Use the J 28733-B in order to push the wheel drive shaft out of the wheel bearing/hub.
10. Remove and DISCARD the wheel bearing/hub bolts.
Important: Ensure that the wheel drive shaft outer seal (boot) is not damaged.
11. Remove the wheel bearing/hub.
Installation Procedure
1. Install the wheel bearing/hub.
Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these
fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
Notice: Refer to Fastener Notice in Service Precautions
