Monte Carlo V6-3.4L VIN E (2000)
1. Connect the body wiring harness to the junction block.
2. Install the junction block tab to the slot in the cross vehicle beam.
3. Install the junction block bolts.
Tighten
Tighten the junction block bolts to 10 N.m (89 lb in).
4. Connect the body wiring harness to the junction block.
Tighten
Tighten the body wiring harness connector bolt to 7 N.m (62 lb in).
5. Install the instrument panel (IP) cluster trim plate.
6. Connect the negative battery cable.
