Monte Carlo V6-3.4L VIN E (2000)
Canister Vent Valve: Service and Repair
EVAP Vent Valve
REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Raise the vehicle. Refer Lifting and Jacking the Vehicle to in Vehicle Lifting.
3. Remove the LT. inner rear fender.
4. Disconnect the EVAP vent valve electrical connector.
5. Disconnect the vent hose from the EVAP vent valve.
6. Remove the EVAP vent valve from the bracket.
INSTALLATION PROCEDURE
1. Install the EVAP vent valve onto the bracket.
2. Connect the vent hose to the EVAP vent valve.
3. Connect the EVAP vent valve electrical connector.
4. Install the LT. inner rear fender.
5. Lower the vehicle.