Monte Carlo V6-3.4L VIN E (2000)
10. Disconnect the coolant temperature sensor electrical connector.
11. Remove the fuel rail retaining bolts.
12. Remove the fuel rail assembly.
13. Remove the injector O-ring seal from spray tip end of each injector. Discard seals. With the O-ring removed, the O-ring backup may slip off of the
injector. Be sure to retain the O-ring backup for reuse.
INSTALLATION PROCEDURE
NOTE:
^
Use care when servicing the fuel system components, especially the fuel injector electrical connectors, the fuel injector tips, the injector O-rings.
Plug the inlet and the outlet ports of the fuel rail in order to prevent contamination.
^
Do not use the compressed air to clean the fuel rail assembly as this may damage the fuel rail components.
^
Do not immerse the fuel rail assembly in a solvent bath in order to prevent damage to the fuel rail assembly.
